Skip to main content

Defined flex track arc in RR-Track

I've searched thru the menus - and was wondering if there is a way to manually define the arc of a full piece of Atlas flex. I'm wanting to use 4 pieces to make a 180° turn using the full piece (minimize waste). I've tried placing 108 curves and then removing a couple and fill in with flex - but I haven't got the spacing down well enough to use the entire piece of flex.

 

Any ideas?

Original Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×