I'm trying to use a 153c and Block Target signal to run two trains on the same track at the same time, but I'm having problems following the directions I found in an old lionel manual, because the transformer shown in the manual has six posts and I am using a CW-80 which has only four posts.
Can somebody explain to me (a diagram would help) how to accomplish this when using a CW-80?
I've got the isolated block set up and the 153c to control it is set up several track sections away, I just need to know how to wire this setup so it will work with the CW-80.
Any advice would be appreciated. Please note, I'm determined to do this with a 153c, so please don't suggest using a rectifier.