Skip to main content

Gents---- I set up this Wabash 3424 car on my inside siding, and when I switched the train into the siding the locomotive immediately went dead.  I believe I installed the low bridge tell tales correctly, but i would like a little advice.

I used the taller set of blades.  The base is locked in tight to the O gauge track.  I am wondering if the blades are touching the center rail somehow, but I look forward to some advice.

Original Post

Never got an answer? I spotted this searching for tell-tale height info .

That base grabs the two outer rail flanges, of the two outside rails.

If you have it on correctly but it shorts, you may have a "dip" in your center rail.

 A few wraps of electrical tape around the post holder under the position of the center rail might help.

Hope you figured it out!

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×