Skip to main content

My layout has several blocks.  One of these blocks is an uphill block.  I have track sensors and relays that can sense the train and flip the relay to A or B.  A is full power (to go up hill) and B is reduced power (to go down hill).  

 

I have a dimmer switch which is used to control 110 volt fan or lighting.  I want it turned to the power needed to slow down going down my hill.  I may have purchased the wrong type but the dimmer (5amp 125v) doesn't have any affect at train voltage.  

 

Does anyone have any good ideas how I can accomplish what I need?

 

Jim

Original Post

Replies sorted oldest to newest

This question comes up a lot. Here is a method using 2 relays where only 1 train runs on a loop in one direction. It can be made bi directional with more relays.  That method is linked in my last post.

 

All 4 taps of PWZW are used along with 2 outside insulated rails to power the relay coils. Note the contacts are configured so that none of the transformer taps are connected together. There is no roller jumping,in fact center rail blocks are not needed if only 1 train is run on the loop only 2 outside insulated rails are needed. Careful placement must be made for these insulated sections as the coil will stay energized as long as any train car with metal wheels sits on the insulated section.Block detection using relays is explained here LINK

 

  All the voltages can be set by the throttles. Click on any diagram to enlarge

 

 

uphill downhill 1

 

If you do not have a multi tap transformer or do not want to use your ZW that way,you can make a voltage divider out of 25 amp bridge rectifiers as shown. Each half of the bridge drops voltage by about .6 to .7 volts so  5 bridge rectifiers will allow a 7 volt voltage drop span adjustable in .6 volt increments. Dropping voltage with diodes is explained more fully here LINK2

 

 

 

 

uphill downhill 2

 

The first circuit would cost maybe $20 to make,depending on how cheap you can get the parts. The bridges cost maybe $3 each additional. Hook taps to a barrier strip for easy adjustment. Here is a pic of a voltage dropper made to vary the speed of super street cars in their respective blocks. Timers and relays switch and vary different voltages.

 

 

ss speed vary circuit

 

Dale H

Attachments

Images (3)
  • uphill downhill 1
  • uphill downhill 2
  • ss speed vary circuit
Last edited by Dale H

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×