Hey guys, I'm trying to resurrect a Rich Yoder 44-tonner that someone had taken apart, painted, and failed to put back together. The light board is no longer attached to any of the power leads coming from the trucks. I believe that this board when wired properly is supposed to send a current to only the headlight in the direction of travel (and may also limit voltage to the lights). So when wired properly, what should this look like? Thanks for the help!
Replies sorted oldest to newest
I reviewed pictures of my RY 44 tonner when I did a TMCC upgrade. There was a Red and Black wire that was connected with the motor leads. Your picture shows the leads to the two led lights in the small black blocks, but not the input to the board.
So my problem is I have a blue and white wire going to each light, and I know they are supposed to be both connected to this electronic board, but they aren't. Then I have two extra blue wires, which I assume supplied power to the board. However i can't figure out where any of the wires connect to the board.
If I install DCC this board will be unnecessary, but I'd like to get it operating in original condition first!
Access to this requires an OGR Forum Supporting Membership
