DZ-1000 wiring ?????

1Drummer:

You need DPDT momentary toggle switches. I use the 15 amp version which is a new definition of overkill but I like the size. Center position if off.

Below is an old picture. I ended up taking the plates off and adding stick on labels.

If you decide to use it is best to look on the internet for the lowest cost. I will also send an electrical schematic if you decide to buy.

Joe

Here's a link to the small momentary dpdt, center off switches from All Electronics (surplus).

http://www.allelectronics.com/...y-mini-toggle/1.html

With the Gargraves switch you need a single pole double throw switch with the center off. I am using the switch controls that come with the Gargraves or Ross switches, I put either the neutral or hot to the center of the switch and the other wire to the switch machine center wire. The two outside wire positions get the momentary power from the throw switch.

Lee Fritz

1drummer posted:

I have 10 DZ-1000s

    I have 10 DZ-1000s
    I have a few controllers(?)

    And one controller will operate more than 1???
    Anyone have wiring information, tips or tricks?

    Testing instructions?

 

Yes, one controller will operate more than one DZ-1000.

Extensive application and wiring information is on the Z-Stuff website.