Skip to main content

I am new to the Forum and need some help.  I have set up the TIU and tried to load a MTH diesel into the hand held device. I keep getting a message saying that there no locomotive present. After several tries, I place another locomotive, in place of the first, and received the same message saying that there was nothing to load. I have set up the TIU to be able to use Fixed 1 port. I also tried using Fixed 2, but even though juice is going in, there is no juice going to the track. What am I doing wrong? Please help, thank you, Jim

Original Post

Replies sorted oldest to newest

Maybe this will help....   first part.... the remote must communicate with the tiu else nothing works period...Hit the  "read" bottom left on the remote and we should get the Message TIU found with no aiu box connected or something very similar, The important part is tiu found. Give it a try,

Second part    The tiu need a power supply to turn on (function operate). Power to fixed 1 or an aux power or both works .  I noticed you tried fixed 2 but fixed 2 is a straight through connection which will allow voltage through  but unless the tiu is turned on there will be no  dcs signal so thinks don't work.

The red out put from the tiu channel must go to the center rail.... try it again....good luck.

 

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×