Skip to main content

I have been searching for a way to connect AC power to a PW un-coupling traction section. I mainly need it for accessory car activation, Milk, Log, and the likes. I can swear I saw somewhere how to do this but I cannot remember where.  If I was imaging this some one please slap me sill side ways. If I wasn't imaging this some one please point me in the right direction.

Original Post

Replies sorted oldest to newest

For RCS, 6019, and 1019 types, disconnect the far right wire from the track at the controller and power the controller(fourth from bottom - top leaf in pile switch) with your ACC voltage.

 

For UCS types, disconnect the third wire from the track at the controller and power the controller(third from bottom - leaf in pile switch) with your ACC voltage.

 

This is the example circuit drawing you want to be looking at:

 

 

RCS 6019 Fixed ACC

Attachments

Images (1)
  • RCS 6019 Fixed ACC

Here is a quick down and dirty explanation for wiring the UCS track for variable voltage:

 

With the four wires facing the four numbered post on the UCS track the wires from the controller  are connected for AC or  also commonly called "variable voltage" as follows:

 

Controller wire 1 is connected to ground on your layout

Controller wire 2 is connected to post #2 on the UCS track

Controller wire 3 is connected to a variable voltage source such as the B or C post on a ZW.

Controller wire 4 is connected to post # 4 on the UCS track.

 

This method comes in handy when the UCS track is located a long way from your control panel.You only need to run two wires on the controller to the UCS track, #'s 2 and 4.

Wires 1 and 3 on the controller will be closer to your power source on the control panel, requiring a shorter run from the UCS controller.

 

It is also helpful to mark the wires on the controller with dots on each wire in order to easily ID each wire.

 

I hope this helps.

 

Richard

 

 

Originally Posted by Richard Gonzales:

This method comes in handy when the UCS track is located a long way from your control panel.You only need to run two wires on the controller to the UCS track, #'s 2 and 4.

As an added benefit, you can also power the track using #'s 1 & 3 from the transformer to the UCS providing, essentially, a "hidden" Lockon feed to that stretch of track.

Originally Posted by RRaddict2:

...Am I correct on assuming that I can use the AC AUX power from the transformer to supply the power and ground source?

That's a loaded question.

 

Generally, yes, and you only need the ACC, as the ground should be common.

 

One notable exception would be the CW-80 versions made before "G" coded date codes as the red posts are common on these instead of the black "U" posts.

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×