On Page Three, it talks about Protection of Layout from Overloads. If there is a Short and the OUTPUT (from the PowerMaster) is shut down, push RESET on the CAB2 to Reset the PowerMaster to Resume Normal Operation. I assume they mean the "0" Button which sometimes is called the "RESET BUTTON"!
Please advise,
Fred
Replies sorted oldest to newest
Still looking for an answer! Someone must have one of these.(I don't, so I can't answer for my Buddy)
FREDSTRAINS
If you look at your Cab-2 when the PowerMaster is selected, there will be an icon on the keypad that looks like a stop sign with a R in the middle. Per the Legacy manual, that is the icon for reset, aka the reset button you seek.
Sinclair,
Thanks, I will pass that on to my buddy. I don't have one of these Legacy PowerMasters as I use a ZW-C to run Legacy on my Layout!
FREDSTRAINS
The online manual say push AUX1, then 0. Effectively the same as Sinclair has stated. Not sure if the on-line manual is as up to date.
Page 15 also echos what Sinclair says.
The Manual says on page 3 to Press AUX1,0... on a Cab1, but RESET on the Cab2 ??
Page 15 says the "O" or "R" to reset output to zero & resets an overload shutdown.
Which is it; the "O" or "R" button OR the ICON that looks like a STOP Sign with an "R" in the middle.
Fred
Aux1, 0 and Reset are effectively the same button and do the same on both CAB1 and CAB2. On Cab2 it just assigns an ICON to represent reset.
I don't have a powermaster to test but I suspect either will work. But yes the stop sign is reset per the Legacy Users Manual.
Thanks Marty & Sinclair,
I think you both have answered my Questions. I will pass the info. on to everyone else involved w/Legacy PowerMasters in our Club!
Regards,
Fred
here is a picture of the cab 2 with the numbers showing and their position.
even if the numbers do not show and you see icons the systems is designed to work as if the numbers were showing. meaning the icons are really the numbers, just in picture format.
Access to this requires an OGR Forum Supporting Membership
