Skip to main content

Hi GUYZ,

  I just purchased a new Reading T1 Legacy 2124 Lionel number 6-83201 and I am having a problem with going up a small incline and also on some straights. I am using Lionel Fast track and using Lionel Legacy Cab 2 controls, track powered by 180 watt brick fixed 18 volts.  The problem is that at slow speed from 1 to 20 on the cab 2 sometimes the drivers will turn but not have the engine move.  I have already changed the traction tires, no difference.  I also have switched out the spring in the rear truck with a spring from my Lionel FEF.  I little better with the traction but still no help on the slight incline.  Any ideas on whats going on with this?  All my other Legacy steamers have no problems with this at all.  Shoulsd I send this back to Lionel?  Any thoughts on this.  Thank you for your time.

Forgot to add the Fast track is clean, no oil or grease on it.

Last edited by laz1957
Original Post

Replies sorted oldest to newest

laz1957 posted:
BobbyD posted:

Picture? The incline may be lifting the drivers (rubber tired included) off the rails.

No it is not lifting the drivers on the incline.   It will come to a spot and just sit and spin.  If I apply a bit more speed it will catch and go but you really got to apply power.  But thanks for input. 

So you are saying it spins on essential flat track then. By itself? No train coupled on?

BobbyD posted:
laz1957 posted:
BobbyD posted:

Picture? The incline may be lifting the drivers (rubber tired included) off the rails.

No it is not lifting the drivers on the incline.   It will come to a spot and just sit and spin.  If I apply a bit more speed it will catch and go but you really got to apply power.  But thanks for input. 

So you are saying it spins on essential flat track then. By itself? No train coupled on?

I am running it with seven 18 inch Lionel Pullman cars.  But even with that I still do not have issues with other Lionel engines pulling the same cars.

Update on the situation.  I changed out the track and also did some shim work for leveling it out.  I did a run by with the T1 and I think YUZ GUYZ were right with the track.  Seems like it might have been a bit un level.   I have to run it again and when the video is ready I'll show the before and after pics.  Thanks again I think it will work fine now.  Seems like a sensitive type of engine?  Never had this happen with any of my other engines?  We will give it some time to see what it does?  Thanks again.

 

I believe I recall a similar issue with Lionels MR S3 which also has the new  kinematic drawbar. The drawbar doesn't let the locomotive "float" like its supposed to, and drawbar ends up supporting most of the weight.

I can't recall if  the owner was able to make an adjustment to correct the problem or not, I think so. I've tried searching for the thread with no luck.

Last edited by RickO

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×