Skip to main content

Hi, My layout is all conventional, I have never had or even seen a Legacy  or TMCC layout and have been thinking about getting a Legacy 990 Command Set to use on my layout. I would like to try out some of the newer Legacy motive power engine sets.

 I have three loops that run off a CW-80 and a ZW. All of the loops have the U post / outside rails connected to each other. The two on the ZW is so I can go from the inside loop to the outside loop through a set of switches.  Both of these loops run off the ZW. The CW is got a jumper to connect the outside rails so a set of 252 crossing gates will run off the CW accessory power when a train on either the inside train running on the CW goes through a block or the outside loop train running off the ZW goes through a block.

The question is will this be a problem with the Legacy system operation??

Thanks,

Original Post

Replies sorted oldest to newest

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×