Skip to main content

Hi Folks,

Need some assistance with my Lionel Legacy Norfolk and Southern SD-70ACe 2663. It is locked in conventional mode. My other legacy engines run fine on layout and test track. However, my NS 2663 starts and remains in conventional mode at start up and then stands still. Only the number board light are on. Cab and forward and reverse lights remain off. Sound works fine.

Any advice is most welcome.

Thanks, Frank

 

Original Post

Replies sorted oldest to newest

Gentlemen thank you for your excellent suggestions. 

PhillyReading- I am fortunate to live near a reputable Lionel repair shop.

KENV-I tried your idea to reprogramming. Unfortunately, when I applied power to the track, the engine would turn on with sounds and the light board lit up. It appears that I can’t get engine to go into program mode.

BIGDODGETRAIN- the 6 dash number is 6-34613.

ROYBOY- It ran properly when I purchased in October 2016 until last Friday.

GGG- I run it in command. The program switch was set to RUN the last time it worked properly.

GUNRUNNERJOHN- I checked all connections and find them to be good. Could there be an issue with R4LC?

Again, I want to express my appreciation for your time, and assistance. At this point, I may bring it to my local hobby shop for their expertise.

Sincerely,

Frank

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×