Skip to main content

I have not been able to find a wiring diagram or info of value for the MTH 30-1074 cross buck grade crossing signal nor do I own one. Before I purchase one does anyone know if I can hook up two or three similar Lionel cross bucks with old style bulbs, not LEDs to it so all flash at once. I have done this with one of  the newer Lionel cross bucks to an older one and wonder how many I can add to the newer  MTH or Lionel crossing signal.  Can the board handle the additional amps or are they a spdt rely etc. I could always hook it up, keep adding one more each test, do a smoke test and when it fails add to my junk pile.  

Original Post

Yes you can. I have done it to two signals. You can hook them up either way don't matter just hot and ground wire and all you have to do hook wires up to both signals and from one signal hook wires up then run to power supply. I looked for a manual and can't find any to show you how to wire it up but i would not hook 4 signals on same power might hurt idk but i have hooked two up never had a problem.  

Last edited by chessie1971

Add Reply

Post
This forum is sponsored by MTH Electric Trains

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×