Skip to main content

Replies sorted oldest to newest

Ace posted:

Your tables are a pretty good size with lots of potential. So you aren't building the angled version shown in the first post? I figured the angled "L" is not such a convenient fit for most spaces. Have you customized a track plan to fit your tables?

I, too, was wondering why you didn't angle the tables. It will change the whole track/layout fitment.

it's a nice looking plan.

Not bad electrically for a single lock-on. I would suggest at least four location for power and common feeds for that loop.

Too bad you couldn't get the angled table into the space.

Have you ever tried spreading the rail from the bottom and inserting a stripped end of wire for a feed? A quick dab of solder makes it nice. A thin blade flat screwdriver and then rotated a little.  I also like the lock-ons that press up into the rail bottom in the same fashion. The side clip dealies seam shaky.

Add Reply

Post
The Track Planning and Layout Design Forum is sponsored by

AN OGR FORUM CHARTER SPONSOR

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×