Skip to main content

Replies sorted oldest to newest

DZ-1000 wiring for automatic non-derailing operation

Here is the non-derail setup recommended by Z-Stuff.  The power is 12 VAC, direct from the accessory posts on your transformer.  You need 12 VAC minimum.  The diodes prevent back current going to the led's on your controller.  You do not need the DZ-1008 relay.

One suggestion - see where the switch approach rails are cut, do NOT cut the rails on the switch.  Cut about a 3"      section of rail before this, on the rail leading up to the switch.  Doing this prevents possible damage to the switch rails.

Bruce

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×