Premier Proto 3 FEF

Hello Adam,

When you add them to the DCS Remote the second one will take the next address.  Each PS-2/PS-3 has it's own address.  The address in the remote will take the next available number.  Add your engine one at a time on your layout and then when you put them all on they can be addressed by the number they are in your remote.  To make them identifiable from each other you can change the name of one of the Engines by going in to the Engine Setup Menu and go to EDIT ENGINE and you can change the engine name.  Then you rename the engine and the engine will keep that new name to show up in your remote.

Thank You,  I will do just that.

How about DCS control of the red hazard light?

Currently, that light is set to be controlled by the LIN softkey in your DCS Remote. This is actually a departure from the norm and it should be on the LBE or Beacon Light control. This is being corrected and a new Consumer Package will available on our website within the next day or two. 

Where do I access the consumer package?  Do I have to reload version 5.0?

Thanks

Where do I access the consumer package?

That would be the Sound File/Chain File download under the "Support" tab on MTH's web page for the engine..

Do I have to reload version 5.0?

No, you do not. Rather, you need to use DCS Loader Program 5.0 to reload the engine's Sound File and Chain File, after downloading them from the engine's MTH web page.

This and a whole lot more is all in “The DCS Companion 3rd Edition!" This book is available from many fine OGR advertisers and forum sponsors, or as an eBook or a printed book at OGR’s web store!

Thanks Barry,

I'm gonna buy your book from the OGR web store.