Skip to main content

Hello again 

locomotive back from the shop this afternoon, unfortunately DOA. Loaded #20-3542-1e into the DCS 4.20, tried to start and all it did was make a humming noise from tender.I Immediately cut power.

 

Is there something I can try or look for? or should it just go back? The shop just replaced all the boards in engine and tender.

Thank you 

Clem k 

Last edited by clem k
Original Post

Replies sorted oldest to newest

Recently had a board replaced in my grandson's MTH GP20, we noted on test run that the one truck jammed/locked-up, which may have caused the board to fry.   Eventually replaced the truck and all was fine.  Not sure why the truck was a problem, looked and operated fine until you put it on the track.

 Mike CT 

Add Reply

Post
The DCS Forum is sponsored by

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×