Skip to main content

I have a question concerning how many motors 1 PS2 or 3 board can power. My thoughts are to install a single motor in the dummy just for some extra pulling power as the train length and my layout grades are putting a single engine under a bit too much stress. Wheel slip from my 4 axle units, the six axles seem to have no issue. Does anyone know if I can add a single extra motor and wire it in to the existing powered unit?  

Thanks in advance for any insight. 

Original Post

Replies sorted oldest to newest

Add Reply

Post
The DCS Forum is sponsored by

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×