Skip to main content

Replies sorted oldest to newest

I assume that you are talking about Fastrack remote control switches.  That being the case, the answer is yes.  You can upgrade the switches using the ERR switch commander.  Go to the Electric Railway (electricrr.com) and read the instructions.  You will need to open the switch to verify that it can be upgraded.

The actual upgrade is ridiculously easy.  I did 10 of them and didn't the need the instructions after the first one.  The only challenge is the 40, or so, screws you have to take out get inside.  The results are worth it.

Good luck.

Thanks to everyone who has helped with my switches. Especially Gunrunnerjohn who came up with magic trick of holding your hand over the switch to get it to work and it did. Then removed the back of the switch and moved the internal antenna around, put switch back together, works perfectly. Can't believe there is nothing in the owners manual that deals with trouble shooting.

Bobby Cox,

   Did you purchase your FTCC Switches used, the new switches come with the controllers unattached to the switch, and you must install them.  There is a full set of instructions in each new FTCC Switch box.  If you purchased the FTCC Switch as new and the controller was installed, somebody used it before you got it.  I have quite a few and never got one with the controller hooked up.  I had to install all of them for usage.  

PCRR/Dave

Last edited by Pine Creek Railroad

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×