Skip to main content

9 replies

SD70 Odd Speed problem--no slow speed

OrindOrindOGR Forum Member

Sent  an email to MTH, but thought I would post here too to make sure it is not something simple/stupid I have overlooked.

3 rail O SD70 under DCS control, PS3--Engine was running, no problems, then engine changed to a very high speed.

Shut system down, restarted--engine responds to all functions, but increasing throttle to 1, 4 second pause then engine takes off at a very high speed--will accelerate more if speed is increased, stops if speed set to 0.

Reset engine from DCS remote (factory reset)--no change

Reloaded software to engine (sound and chain files)-no change in behavior.

Other MTH engines (GP40, SW1500) work just fine.

Lionel fastrack, DCS system (5.0) with MTH power brick, DCS signal 10's.

System has been running fine, no changes occurred.

At this point, looking like a repair from MTH, but again, wanted to check and make sure I am not missing the obvious.

Original Post

Replies sorted oldest to newest

OrindOrindOGR Forum Member

No loose connections.  Black/White striping looks new--bright white, black black.  Sensor appears to be solidly mounted--looks like it will head to MTH for repairs---I figure I should hear from them by Wednesday next week--Engine is packed in factory box and ready to go.  Nice thing is I have two other engines to run so all is good.

G GGGOGR Forum Member
phillyreading posted:

Was it shipped a long distance? It might have a connector out of place. I had a PS-2 engine that was acting up and I took it to an MTH repair shop in Miami FL and they fixed within 10 minutes or so, loose connector plug at the tach reader.

Lee Fritz

Will not be applicable for PS-3 since the connector is a single on with all outputs less motor.  So if it was loose, no lights, smoke, sounds on diesel etc....  G

P phillyreadingOGR Forum Member
GGG posted:
phillyreading posted:

Was it shipped a long distance? It might have a connector out of place. I had a PS-2 engine that was acting up and I took it to an MTH repair shop in Miami FL and they fixed within 10 minutes or so, loose connector plug at the tach reader.

Lee Fritz

Will not be applicable for PS-3 since the connector is a single on with all outputs less motor.  So if it was loose, no lights, smoke, sounds on diesel etc....  G

Thanks for the information GGG! I am not that knowledgeable about the new PS-3 systems, so you are saying it is all or nothing then.

Lee Fritz

Add Reply

Views: 227
Post
The DCS Forum is sponsored by

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

Membership Required

We're sorry. You must be signed in to continue. Sign In or Register
×
Are you sure you want to remove from your Block List?
×
Loading...
×
When you block a person, they can no longer invite you to a private message or post to your profile wall. Replies and comments they make will be collapsed/hidden by default. Finally, you'll never receive email notifications about content they create or likes they designate for your content.
Note: if you proceed, you will no longer be following .
×
Link copied to your clipboard.
×

Access to this requires an OGR Forum Supporting Membership

OGR Forum Supporting Membership

Help support this forum with an OGR Forum Supporting Membership.
You will be able to watch the videos in the INSTRUCTIONAL VIDEO FORUM!
A one-year OGR Forum Supporting Membership is only $12 per year, so sign up now!


    OR     


Access the ALL the OGR VIDEO FORUMS AND  over 300 back issues of OGR
with a DIGITAL SUBSCRIPTION!



$12.00 per 12 Months (plus tax if applicable)
×