Skip to main content

Reply to "0 scale drivers"

Thank you all for the many suggestions.  There are so many sites to browse through and try to figure out what I’m doing...  and figure out where I can compromise.  My basic project is to attempt to model a Reading G3 in S scale.  The 0 scale drivers would be around 60” to get my 80”… that part actually looks doable.  Pilot wheels are a bit tougher.  My 36” is your 27”.  Slaters looks like they might have something close enough in their wagon wheel sets.  Not sure about the prices though.

 

I finally looked up the 0 scale wheel profile in the NMRA standards and was surprised to find them very close to S scale.  I was hoping they would be closer to S Hi-rail (not to be confused with Am Flyer).  However, I do run some scale profile wheels so that shouldn’t really be a problem for me.

 

Thanks again,

 

Tom Stoltz

in Maine

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×