Skip to main content

Reply to "182 Magnetic Crane Controller Wiring"

Raising4--  Can you verify that your wiring changes, taking the two three-wire cables entering the pix of the wiring of the push-button switch as being left to right connected from the numbered points 1 thru 6 on the crane's terminal board, are as follows, clockwise from A on that pix:  A, B, C, D, F, E.  That is, 1-4 in clockwise order, then 6, finally 5 (using the existing solder as a guide)?

I'm referring to your crane after you got it to work.  That information would be very useful to forum members who find themselves with the same problem.  BTW, good work!  --Frank

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
330-757-3020

www.ogaugerr.com
×
×
×
×
×