Legacy & Remote & Command Base work together. Other TMCC engines entered work. 2-8-8-2 will not take a command at the Proctor Historical Museum Layout.
I took the engine to my home layout and replaced the dead battery and ID# 35 installed in my Legacy System and everything works fine in DCS and Legacy Remotes. Problem solved, so I thought. Back to the Museum layout. Reconnected Legacy Command Base setting the frequency # and pairing the # with the Legacy remote. Reinstalling engine # 35 in the remote. No horn or flashing light. Went through the reset engine as per the manual problem solving. I did the procedures Base & Remote, and Frequencies many times. I even disconnected the DCS and did the process in Legacy only and no response.
We also have a older TMCC Base disconnected and a Remote with an Antenna. Could the Remote interfere even not in use?
Because the engine is big heavy and articulated instead of removing it from the Track on and off I merely shut the power off and the Transformer off. Then go through the Program & Run procedures. Is this wrong?
Gerry
