Hit a snag. I got roller assemblies from the Lionel 0-6-0T because the small drivers leave very little space between the frame and the railhead, so I needed a very shallow setup. There are only a few places where I could attach rollers to the bottom plate, due to the drive axles and frame members being in the way, and now I can see that the roller assemblies are just not going to work. On top of it, I test-fit one to check for clearance and the arm spring took so much weight off the drivers, no amount of lead in the boiler would make up for it. I think my only choice is a power pickup trailer car, since there's no tender. I have a Lionel 40' flat that I'll use (since this will be a rock quarry switcher), so now my task is to figure out how to get rollers on that. Anybody need the 0-6-0T pickup assemblies?
|