Skip to main content

Reply to "3D Printed Block Signals - LED wiring and Connectors Added"

Alan,

I love the details in your designs.

One of my challenges was to have room behind the front face for the 5mm LED and PCB board (I only wanted the LEDs to peek out of the face)

When I get home I will post pictures of the PCB board and the wiring.

I also have a designs for "Darth Vader" face plates.  I like the look, but it is harder to see the LEDs.

I also preferred don't to show the wires and didn't know how to do that with the bends in the pipe.

There is also an O-Gauge block signal on Thingiverse but it has a "No Derivatives" License.

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×