Skip to main content

Reply to "3rd Rail Cruise Commander to Add Speed Control to 1998 Vintage TMCC?"

I just use my serial data buffer and leave all the drawbar stuff alone.  Just connect the yellow lead to the serial data going to the Cruise Commander M, and the others to the listed R2LC socket pins, and job done.

This insures that the CC-M gets good serial data, and leaves the other wiring and signal levels just as it was before the installation.

FWIW, I have exactly the same locomotive, and I used this as well as installing my Chuff-Generator and Super-Chuffer II, this gives me 4-chuffs/rev, chuffing smoke, smoke at idle, Rule-17 LED headlight, and automatic cab light control.

Last edited by gunrunnerjohn

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×