Skip to main content

Reply to "497 Coaling Station Question"

If you want to isolate the coaling station from the base, the dump solenoid and the left-hand brush holder must be disconnected from the motor.  This is where both are grounded to the frame.  By removing these two wires, and connecting a lead to them, you can power the loader with the single lead from the controller and the new ground lead from the loader.  Not sure how the Williams dump car works, but reply if you need to use the power blade on the loader and I can explain how to wire it.

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
330-757-3020

www.ogaugerr.com
×
×
×
×
×