So I can jump a wire from the collector roller to pin #1, for positive. And I can install a ground wire. Do I just solder wires onto the existing wires on the chuff switch, and run them to the Super Chuffer. And leave the original ones that are on the chuff switched, still hooked up ? And do I just tap into the smoke unit, and smoke heater wires. Or do I have to disconnect them completely from the smoke unit motor and heater element. And run new wires from the Super Chuffer to them. I guess what I am really asking, is do I just tap into the existing wires. Or do I actually need to remove any of the original wires to hook this Super Chuffer up. Thank you very much for your advise and patience. I have the ability to tear these locomotives down, and change the worm gears, and completely service them. But electronics has always been an interest to me, but never my field.
|
|
