Skip to main content

Reply to "Adding a CC-M"

That means I soldered to the wrong place on the switch.    I'll try it with making the switch normally open. 

Always another question.  Do you happen to know if on the ERR 10 Pin Wire Harness Set more than one wire connected to the printed circuit board is grounded through the board's hold down screws.  I'm not surprised one is, but two are; orange and green.   

Sorry, one more.  How did you find out about the TMCC chuffs vs. Legacy?   Just kidding! 

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×