Hello! It's been awhile but I just sat down to try and finish wiring LED lights in this engine but I've run into a couple problems that have me scratching my head. I bought the 220 ohm resistor to add to the LED but have no idea how to hook it up to the light. (That sounds stupid but this is new territory for me.) After I figure that out, I some how need to wire the headlight and added strobe light to the directional control for the DCS engine. (When I have it in forward, the strobe and headlight come on, when I throw it in reverse they go out, etc.) I think I just need to tie into the two wires that connect to the bayonet base of the bulb but am not really sure, I tried that and now can't seem to pin-point a power and a ground from the two. I traced it back to a little two-pin plug with a blue and a purple wire to it. I would think that they would be a power and a ground but I'm not sure. After I get this figured out, I would like to add marker lights to this E8 as well and somehow need to pick up power for them too. This sounded like a much easier project in my head. 
Thanks,
