Skip to main content

Additional O Scale Transformers (Help!)

Hello all, I currently have an MTH DCS layout powered by a Z4000, through both handles. On the left, I have a main table with three main loops of track along with some sidings. On the right, I have two simple loops around the ceiling of the room. On the main layout, I have a Lionel Legacy Polar Express with 8 lighted passenger cars, an MTH Premier GP38 with non-powered unit, and a new addition, two MTH Premier Dash-8 engines. Everything has been fine until I got those Dash-8 engines. When all three lines are running at once, the transformer hold for about a minute, and then overloads. In order to fix this, can I just add say another Z1000 brick onto the current TIU input/output? Or do I have to create a new block on the layout and run it out of one of the other TIU outputs?

Any help is sincerely appreciated.

Thanks, PhoebeSnow
Original Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×