Skip to main content

Reply to "AF #760 crossing flasher"

I will assume you have tried it bare naked on bench without the signal, ie just two bulbs/LEDs hooked to board outputs with correct input voltage?  If no go, insert a meter to read board current draw, If next to zero reading then probably board is defective.  If high current with no load then might be a bad partially shorted component(s).

Just some ideas.

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×