Skip to main content

Reply to "After upgrade it stalls after a couple of feet?"

Usually I would but it's been about a year since I just put it on the shelf to figure out later.  I also don't want to pay the $40+ shipping/insurance to send it to the East Coast from Oregon or have it bashed to pieces during shipping again.

I'm hoping I can find a solution myself as it does run okay under Conventional.

After all, it's "just an old Williams" and I don't want to sink a lot more bucks into it.

And I have a lot of upgrade kits coming for my Proto fleet of turbines, etc., so perhaps I'll get lucky on finding the solution, with the good hints from you-all, when I get to "benchwork time"

 

Originally Posted by NROD:

I would contact who did the work and tell them I was returning it to be made right. Be sure to advise them of its condition when it arrived. If they have any scruples at all they will help you here.

 

Rod

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×