Skip to main content

All PS3 installed in an Atlas engine.All working except leds which i havn't figured out yet.

  I would like to use the original mounted led lights in the atlas shell and connect them to the PS3 led connecters. A quick voltage ck at the ps3 led conn gives me anything from .16 to .68 depending which conn i am checking[ck made while ps3 lights are on and just hanging loose]. Is this a series pulsed dc set up?

  Can i remove the atlas regulator boards and wire in somehow with out loosing DCS command of the lights or am i better off using a voltage source with dropping resistors that probably would negate DCS light commands?

 

Original Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×