Skip to main content

Reply to "Another LED constant lighting question for passenger cars . . ."

gunrunnerjohn posted:

You can also just swap out the 27 ohm resistor for a larger value that will lower the adjustment range.

So to be sure I “got the gist” of what you advise, if I use a larger value pot, I increase the range of brightness control to the lower end, but if I use a higher value resistor at R1, I move the whole range lower.  Which means not as bright at the highest level.  Which for my taste is not a problem.  What would the value of R1 change to?  50 Ohm; 100 Ohm or more/less?  Thx again for the help.

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×