Skip to main content

Reply to "Another "What's wrong with my Locomotive?" Thread"

The R2LC also controls Cruise board or motor driver.  It is an easy swap to see if that resolves your issue.  But while you are in there inspect the motor driver board for damage.  Make sure all connector are attached, no wires off motor.  Rotate motor flywheel to ensure you do not have binding of motor (tires off and stuck, linkage out of adjustment, brake detail stuck on driver, etc...)  If binding it may cause your symptom.  Other wise R2LC, Motor driver or a bad wire connector.  Wire breaks under insulation at connector.  Or else corrosion builds up so unseat 4 pin on motor driver and reseat.  Tracking this down if no obvious damage to motor driver board is a lot more involved.  G

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×