Skip to main content

Reply to "Anyone Using the LCS SER2 Serial Data to Drive DZ-2500 Switch Machines?"

Grasping at straws... probably of NO use... but, Found this...

Lionel changed the output current on the Legacy command base.  That has screwed up the Z-Stuff DZ-2001 data wire driver.  Dennis Zander of Z-stuff has figured out how to fix the problem by changing a resistor on the DZ-2001 board.

And this... DZ2500 - If all was well with TMCC... hook it up in parallel with the Legacy base connect the common to the Legacy base rather than the TMCC.  This way you could use both CAB-1 & 2 and operate the switches with the signal being converted from Legacy to TMCC.

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×