Skip to main content

Reply to "Armature Overheating"

I once had to re-solder an armature wire to the plate on a Champion motor, which had the armature holders riveted to the motor frame.  No taking that armature out!

It took a lot of patience, but I was able to do it.  However, that was 30 years ago when I was fresh from the USN, where I was an Electronics Technician!

That motor still runs great!

NWL

LOL NWL! I had to take 1 wind off of each pole and re-solder to the comm plates.  Silk and lacquer and years of thorough oiling makes that very tough.

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×