Skip to main content

Reply to "Atlas 6927 - cannot wire"

thanks - so here is what i did - i turned over the Atlas controller and banged each of the hex nuts so they would go further into the body of the connector - then i tried a thin spade connector and it slipped in fine and i was able to tighten each of the screws - the manufacturing of the connector did not "drive" the nuts far enough in the body of the connector to enable the screw to have room for a wire or a spade connector.  I just had to make sure not to hit the nut too hard - just enough to drive it into the body enough.  anyway now i can use it.

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×