Skip to main content

Reply to "Atlas O Switch Failures"

I was just about to ask, how do you prevent the plastic ties from melting when you use so much heat from a soldering iron?

Has anyone had problems with the plastic ties melting right away?

Last question, do the current run of turnouts from China correct any of these problems?

I’ve melted the spikes on the ties with soldering. I just epoxy the tie to the bottom flange of the rail.
Alan

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×