Skip to main content

Reply to "Atlas O switch wiring"

Will try to send a pic when I get home. Basically I solder 18 gauge wire to the Atlas rail joiners (6 common and 3 hot). That's a soldering operation even I can do. Then feed the wires through the table and connect to the grid. It's kind of a pain but the best way to insure no dead spots if the jumpers on the other side are poor. On span, I have lots of engines with only two rollers with a short span and have no trouble with my 036 and 054 switches.

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×