Skip to main content

Battery powered radio control Alco RS-11 by GRJ

Gunner John has a new trick.  He installed a battery R/C unit into my 2 rail (yes I know this is a three rail forum, just hold on a little) RS-11. 

This combo is a neat little bit of encouragement for me.  Quite a few of my yards and one branch line are not fully wired as yet  due to a management/labor issue.  That trackage has been  scenery up to now.  Well, tonight I have fully rolled over all railheads with out turning on any line voltage.   The reason I post this here is because after I ran over 800' of 2 rail track I just picked up the unit and set it on my three rail eye level route.  The two rail RS rolled over the GarGraves and Ross  with out a flinch.  Plus the GarGraves consisted of shallow 11 degree wyes, 0-72 LH, RH & 0-72 Wye switches.

This is truly an engine for all railroads.  Thank you Gunner John!!

I should have gone Battery R/C from the very beginning.  Think about this newbies and post war folks.

 

Original Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×