Did some prep work on the roof section.
I sanded the bottom smooth then spent time removing flash from the bottom edges - at least I hope it was flash. Looking at the finished picture this may have been a ledge, however large chunks were missing so I had no choice here. I also discovered one of the corbels was damaged with about half of it missing. Metal corbels came with the kit that I was supposed to glue to two sections so I used one for repair. There will be one missing corbel but it is in an area where I don't think it will be noticed.
Next up are the metal bay windows.
If the roof does not look right when seated to the walls I will add a styrene sheet to act as a ledge.
The missing corbel - plus a chunk taken out of the top trim. I sanded the area smooth, added Squadron putty to the top and glued in a metal corbel.
I still need to add some putty to the small corbel on the left.
These are the two sections one needs to glue in corbels.