Skip to main content

Reply to "Best track nips?"

@Rail Dawg posted:

My bad for using the term "nips".

Is it ok to use the term nippers or should I use the term cutters? You used both terms so it's ok either way?

I didn't mean to post a confusing message. Thanks for the input!

Chuck

I was more or less just trying to clarify what you were looking for. Micromark calls them Rail Nippers. But Xuron calls them Track Cutters.

Either way, they launch the piece that you snip. Aim into the table or you'll send the cut end flying.

Last edited by Boilermaker1

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×