Skip to main content

Reply to "BPC HELP"

Paul, 

yes I removed the BPC jumper pin cover then assigned acc 1, presuming 2, 3, and 4 were sequentially assigned by the BPC, then replaced the jumper cover.

so this is my understanding of the procedure;

Press acc - the command to start inputting  data to the bpc

Press 1 or 2 or 3 or 4 - the block of track I want to control

Press aux1 - opens the numeric keypad

Press 1 or 2 - assigns the block to one of the tpc’s.

Do you do this every time you run your trains?  

So, only one relay can be closed at a time? 

One other crazy question if I may, are the dat and com wires attached to your tpc’s?  The bpc manual doesn’t show them attached but I think they Lionel left them off the picture just for clarity.

thanks again for sticking with me. 

9925C2D1-5694-4CC5-BD2D-45A3C1AA1632 

 

Attachments

Images (1)
  • 9925C2D1-5694-4CC5-BD2D-45A3C1AA1632: BPC manual page 7, rev-12/01

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×