Skip to main content

Reply to "Broken power connection on an MTH WIU...Help!!"

This happens so often that MTH issued a service bulletin addressing the replacement.   I've received quite a few of these boxes to repair the jack.  If it were soldered on properly at the factory, this wouldn't be such an issue.

The arrows show where the jack should have been soldered, and the other shots show what I did to make sure it didn't come off again.

The replacement jack is Digi-Key P/N - WM3756CT-ND.

Make sure you solder both sides of the PCB where the support tabs come through, that's what was missing in the original installation.






Thanks so very much for your info...extremely helpful!!

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×