Skip to main content

Reply to "CAB-1L & Base-1L problems"

I have an o-gauge PA 411 Switcher that is a run-away (takes off like a bat out of ****) when I turn on the 180 watt power house. I can stop the run-away by placing my hand over its top to block the radio signal. It works but does nor respond to the cab and power base 1L. I was told to make sure the rails are grounded because they serve as an antenna. They look good. I assume it must be a circuit board. Need help!

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×