Skip to main content

Reply to "CAB-1L & Base-1L problems"

I have an o-gauge PA 411 Switcher that is a run-away (takes off like a bat out of ****) when I turn on the 180 watt power house. I can stop the run-away by placing my hand over its top to block the radio signal. It works but does nor respond to the cab and power base 1L. I was told to make sure the rails are grounded because they serve as an antenna. They look good. I assume it must be a circuit board. Need help!

NOOOOO!  DO NOT GROUND THE RAILS! The outside rail(s) connect to the command base TMCC connection, but most assuredly do NOT get grounded!  The "ground" comes into play with the 3rd prong of the command base power connection to the wall outlet.  However, that house ground must NOT be connected to the tracks!

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×