I just reloaded my Cab and Base from the modules I will use for upgrade which were freshly made from the laptop that I will be making modules if needed. So the entire chain has been tested.
If you are going to get updated by me try to be there about 15 minutes before the end of the hour of time I outlined above.
Again this is for anyone whether on this forum, another forum, or whoever. I don't think you'll have any problem finding me. From the post above...
In the Orange Hall Lobby to the right of the center entrance between the modular layout and the meeting room, I'll setup somewhere on both Thursday and Friday.
Thursday will be from 3:30pm to approximately 4:30pm Friday will be between 11:30 am to around 12:30 pm. I'll be departing Friday so I would like to make another pass in a few halls Friday afternoon so try to make it between those times on Friday.
I will have everything I need to create and test base and or Cab2 modules (you will have to supply 2 writable modules or 1 if you just need the Cab2 update). I will have my PC and a 990 system to make and test before you leave. Here is GRJ's Make a Writable Module thread.
I will also have a Base and Cab2 module for those who want to bring their 990s. GRJ also said he'd bring a set of modules and will be at Henning's booth (check with him for times). Between the 2 of us we should be able to cover everyone. From my end, I only ask to try to get there before the end time so I can get you in the que. If you know anyone on other forums that needs an upgrade point them to this post. All are welcome.
If for some reason these times don't work for you we'll figure something out.
