Skip to main content

Reply to "Can't get MTH NW 2 diesel to work"

Jeff,

When you start  a PS1 after it has been sitting for a bit, do not go above 10v. I usually advance the throttle until I hear the sounds start, and then wait for about a minute. That puts a bit of a charge on the battery, or if you have a BCR, charges that. Then drop the voltage to zero and advance the throttle until the engine moves. If you hear a single "Ding" and "PSSSSSSSH", you are in Reset, and the engine will not move. If that happens, drop the throttle to zero, wait a full minute for the sounds to fully shut down, and try again to no more than 10 v.

Chris

LVHR

Last edited by lehighline

OGR Publishing, Inc., 1310 Eastside Centre Ct, Suite 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
×